Server Technology PT40 Installationshandbuch PDF herunterladen (Seite 8)

Installing the Power Input Retention Bracket

For units with a total maximum output <30A, it may be

necessary to install the power input retention bracket prior to

mounting the unit within the rack.

To install the power input retention bracket:

1. Remove the two screws attaching the IEC 60320 C19 inlet

to the enclosure.

2. Assemble and attach the retention bracket to the enclosure

as shown.

Figure 2.1 Retention Bracket assembly

Mounting

Figure 2.2 Mounting

Horizontal/Rack

1. Select the appropriate bracket mounting points for proper mounting depth within the rack.

2. Attach the brackets to these mounting points with two screws for each bracket.

3. Install the enclosure into your rack, using the slots in each bracket. The slots allow about ¼ inch

of horizontal adaptability to align with the mounting holes of your rack.

NOTE: A mounting bracket kit for 23” wide racks or cabinets is available. Contact your Server Technology Sales

Representative for more information.

Vertical

1. Attach the removable flanges to the mount points on the rear of the enclosure using M4 screws.

2. Attach the mounting L-brackets to the flanges with the supplied screws, washers and nut plates.

The slots allow about 1½ inches of vertical adaptability.

3. Attach the top and bottom brackets to your rack.

NOTE: Contact your Server Technology Sales Representative for information regarding custom bracket design and

fabrication services if you are unable to find a suitable manner for utilizing the included mounting brackets.

Optionally, the supplied button mounts may be used for mounting the CDU into cabinets supporting

this method of equipment mounting.

8 • Installation Smart Cabinet Distribution Unit

Installation and Operations Manual

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 89 90

Keine Kommentare

Server Technology PT40 Installationshandbuch Seite 8