Server Technology PT40 Installationshandbuch PDF herunterladen (Seite 25)

Smart Cabinet Distribution Unit Operations • 25

Installation and Operations Manual

Command Line Interface

Logging In

Logging in through Telnet requires directing the Telnet client to the configured IP address of the unit.

Logging in through the Console (RS232) port requires the use of a terminal or terminal emulation

software configured to support ANSI or VT100 and a supported data rate (300, 1200, 2400, 4800, 9600,

19200, 38400, 57600, or 115200 BPS) - 8 data bits-no parity-one stop bit and Device Ready output

signal (DTR or DSR).

To log in by RS-232 or Telnet:

1. Press Enter. The following appears, where x.xx is the firmware version:

Sentry Version x.xx

Username:

NOTE: Logging in by Telnet will automatically open a session. It is not necessary to press Enter.

2. At the Username: and Password: prompts, enter a valid username and password. And press Enter.

You are given three attempts to enter a valid username and password combination. If all three fail,

the session ends.

NOTE: The default Sentry username/password is admn/admn.

When you enter a valid username and password, the command prompt (Smart CDU:) appears. If a

location identifier was defined, it will be displayed before the Smart CDU: prompt. See

Creating a

location description:

on page 36 for more information.

Commands may be entered in any combination of uppercase and lowercase. All command characters must

be entered correctly; there are no command abbreviations. A user must have administrative privileges to

use the administration commands. The following tables list and briefly describe each command.

Operations Command Summary

Command Description

Connect Connects to a serial/Pass-Thru port

Envmon Displays the status of the integrated Environmental Monitor

ILoad Displays the status of the infeeds

IStat Displays the status of the infeeds

List Ports Lists all accessible serial/Pass-Thru ports for the current user

Logout Ends a session

Password Changes the password for the current user

Quit Ends a session

UPSStat Displays the status of the associated UPSs

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 89 90

Keine Kommentare

Server Technology PT40 Installationshandbuch Seite 25