Server Technology PT40 Installationshandbuch PDF herunterladen (Seite 73)

Smart Cabinet Distribution Unit Advanced Operations • 73

Installation and Operations Manual

Logging

The Sentry family of products supports logging of system events both internally and externally. An

internal log of more than 4000 events is automatically maintained and is reviewable by administrative

users. For permanent/long-term log storage, Sentry supports the Syslog protocol. And for immediate

notification, Sentry supports Email notifications.

Log entries include a sequential entry number, a date/time stamp and an event message. The event

message is preceded with a message ‘type’ heading and if the event is tied to a user, the username will

be included.

NOTE: For date/time stamp support, SNTP server support must be configured. For information on SNTP, see page 20.

The Sentry supports the following event message headers:

• AUTH: All authentication attempts.

• POWER: All power state change requests.

• CONFIG: All system configuration changes.

• EVENT: All general system events. Example: over/under threshold event.

Internal System Log

The internal system log is stored in the local memory and has support for up to 4097 continuously aging

entries. The internal system log is only available to administrative users. For instructions on reviewing

the internal log, see page

24.

Syslog

The Sentry’s Syslog support is RFC3164-compliant and enables off-Sentry viewing and storage of log

messages. The Sentry supports external logging to up to two Syslog servers.

Syslog Command Summary

Command Description

Set Syslog HostIP Sets the IP address of the Syslog server

Set Syslog Port Sets the Syslog server port number

Show Syslog Displays all Syslog configuration information

Setting the Syslog server IP address:

The Set Syslog HostIP command sets the TCP/IP address of the Syslog server.

To set the Syslog server IP address:

At the Smart CDU: prompt, type set syslog, followed by hostip1 or hostip2 and the Syslog server’s IP

address. Press Enter.

Example

The following command sets the primary Syslog server IP address to 56.47.38.29:

Smart CDU: set syslog hostip1 56.47.38.29<Enter>

Changing the Syslog server port:

With Syslog support enabled, the Syslog server watches and responds to requests on the default Syslog

port number 514. This port number may be changed using the Set Syslog Port command.

To change the Syslog port:

At the Smart CDU: prompt, type set syslog port, followed by the port number and press Enter.

Example

The following changes the Syslog port number to 411:

Smart CDU: set syslog port 411<Enter>

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 89 90

Kommentare zu diesen Handbüchern

Keine Kommentare

Server Technology PT40 Installationshandbuch Seite 73

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Server Technology PT40