Server Technology PT40 Spezifikationen PDF herunterladen (Seite 40)

HTTP Administration

NOTE: A restart is required after setting or changing ANY Telnet/Web configurations. See Performing a warm boot on

page 38 for more information.

Enabling and disabling HTTP support

The Set HTTP command is used to enable or disable HTTP support.

To enable or disable HTTP support:

At the Sentry: prompt, type set http, followed by enabled or disabled and press Enter.

Changing the HTTP server port

With HTTP support enabled, the HTTP server watches and responds to requests on the default HTTP port

number 80. This port number may be changed using the Set HTTP Port command.

To change the HTTP port:

At the Sentry: prompt, type set http port, followed by the port number and press Enter.

Example

The following changes the HTTP port number to 2048:

Sentry: set HTTP port 2048<Enter>

Setting the HTTP authentication method

The Set HTTP Security command is used to set the method of authentication. The Sentry HTTP server

supports two authentication methods for security and validation of the username-password – Basic and MD5

digest.

For more information on authentication methods, see Setting the HTTP authentication method: on page 14.

To set the HTTP authentication method:

At the Sentry: prompt, type set http security, followed by basic or md5 and press Enter.

Telnet Administration

NOTE: A restart of the Sentry is required after setting or changing ANY Telnet/Web configurations. See Performing a

warm boot on page 38 for more information.

Enabling and disabling Telnet support

The Set Telnet command is used to enable or disable Telnet support.

To enable or disable Telnet support:

At the Sentry: prompt, type set telnet, followed by enabled or disabled and press Enter.

Changing the Telnet port

With Telnet support enabled, the Telnet server watches and responds to requests on the default Telnet port

number 23. This port number may be changed using the Set Telnet Port command.

To change the Telnet socket:

At the Sentry: prompt, type set telnet port, followed by the port number and press Enter.

Example

The following changes the Telnet port number to 7001:

Sentry: set telnet port 7001<Enter>

40 • Operations Sentry Commander - PT40

Installation and Operations Manual

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 73 74

Keine Kommentare

Server Technology PT40 Spezifikationen Seite 40